如果交換機的login密碼忘記了咋辦啊?
別急別急,只要你有PC,有類似超級終端(Hyper Terminal)這樣是終端程序,連接到交換機的console口,那么密碼的恢復就簡單了。
1.對于Catalyst 2900/3500XL系列來說:
拔下交換機的電源線,然后按住交換機的Mode按鈕,再重新插上交換機的電源線.直到端口Port 1x的LED熄滅之后釋放Mode按鈕。
就這么簡單,別告訴我你不知道Mode按鈕在哪啊。
2.對于Catalyst 2940/2950L系列來說:
拔下交換機的電源線,然后按住交換機的Mode按鈕,再重新插上交換機的電源線.直到STAT的LED熄滅之后釋放Mode按鈕。
3.對于Catalyst 2955系列來說:
Catalyst 2955沒有沒有外部的Mode按鈕,因此就不能使用之前的那種方法來進行密碼恢復.在交換機啟動時,對于Windows系列的PC,按下Ctrl+Break鍵;對于UNIX系列的工作站,按下Ctrl+C.如下:
C2955 Boot Loader (C2955−HBOOT−M) Version 12.1(0.0.514), CISCO DEVELOPMENT TEST
VERSION
Compiled Fri 13−Dec−02 17:38 by madison
WS−C2955T−12 starting...
Base ethernet MAC Address: 00:0b:be:b6:ee:00
Xmodem file system is available.
Initializing Flash...
flashfs[0]: 19 files, 2 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 7741440
flashfs[0]: Bytes used: 4510720
flashfs[0]: Bytes available: 3230720
flashfs[0]: flashfs fsck took 7 seconds.
...done initializing flash.
Boot Sector Filesystem (bs:) installed, fsid: 3
Parameter Block Filesystem (pb:) installed, fsid: 4
/---接下來交換機會在15秒內自動啟動,等出現該信息之后,按下Ctrl+Break鍵或Ctrl+C鍵----/
The system has been interrupted prior to initializing the flash file system to finish
loading the operating system software:
flash_init
load_helper
bootswitch:
接下來輸入flash_init命令:
switch:flash_init
Initializing Flash...
flashfs[0]: 143 files, 4 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 3612672
flashfs[0]: Bytes used: 2729472
flashfs[0]: Bytes available: 883200
flashfs[0]: flashfs fsck took 86 seconds
....done Initializing Flash.
Boot Sector Filesystem (bs:) installed, fsid: 3
Parameter Block Filesystem (pb:) installed, fsid: 4
switch:
接著輸入load_helper命令:
switch:load_helper
switch:
再輸入dir flash:命令顯示交換機的文件系統:
